Octavia Mk2
|
| 1 - | Eccentric bolt |
| q | after slackening perform vehicle alignment → Chapter |
| q | do not turn more than 90° to the right or to the left (i.e smallest to largest adjustment possibility) |
| 2 - | Nut, 95 Nm |
| q | self-locking |
| q | replace after each removal |
| q | Always tighten bolted connections in unladen weight position → Chapter |
| 3 - | Eccentric washer |
| q | Inner hole with lug |
| 4 - | Eccentric bolt |
| q | after slackening perform vehicle alignment → Chapter |
| q | do not turn more than 90° to the right or to the left (i.e smallest to largest adjustment possibility) |
| 5 - | Nut, 95 Nm |
| q | self-locking |
| q | replace after each removal |
| q | Always tighten bolted connections in unladen weight position → Chapter |
| 6 - | Eccentric washer |
| q | Inner hole with lug |
| 7 - | Assembly carrier |
| q | removing and installing → Chapter |
| q | Assignment → Electronic Catalogue of Original Parts |
| 8 - | Screw, 90 Nm + 90° |
| q | replace after each removal |
| 9 - | Bottom suspension arm |
| q | removing and installing → Chapter |
| 10 - | Screw |
| q | replace after each removal |
| 11 - | Nut, 90 Nm + 90° |
| q | self-locking |
| q | replace after each removal |
| q | Always tighten bolted connections in unladen weight position → Chapter |
| 12 - | Screw, 130 Nm + 90° |
| q | replace after each removal |
| q | Always tighten bolted connections in unladen weight position → Chapter |
| 13 - | Top suspension arm |
| q | removing and installing → Chapter |
| 14 - | Nut |
| q | self-locking |
| q | replace after each removal |
| q | tightening torque must be applied via the screw - Pos. 12, in order not to put the bearing under tension |
| 15 - | Washer |
| 16 - | Nut |
| q | self-locking |
| q | replace after each removal |
| q | the tightening torque must be applied via the screw, in order not to put the bearing under tension |
| q | Always tighten bolted connections in unladen weight position → Chapter |
| 17 - | Wheel-bearing housing |
| q | removing and installing → Chapter |
| 18 - | Washer |
| 19 - | Screw, 130 Nm + 90° |
| q | replace after each removal |
| q | the tightening torque must be applied via the screw, in order not to put the bearing under tension |
| q | Always tighten bolted connections in unladen weight position → Chapter |
| 20 - | Track rod for rear axle |
| q | different versions |
| q | closed in direction of travel (track rods on the right and left differ) |
| q | opened towards the bottom (track rods on the right and left are identical) |
| q | combined installation is not allowed |
| q | Assignment → Electronic Catalogue of Original Parts |
| q | removing and installing → Chapter |
| 21 - | Screw |
| q | replace after each removal |
| 22 - | Nut, 90 Nm + 90° |
| q | self-locking |
| q | replace after each removal |
| q | Always tighten bolted connections in unladen weight position → Chapter |
