The stationary heights specified in the table apply for the dimension -a-. |
Before the chassis alignment and the adjustment of the steering geometry, lock the steering wheel in the middle position of the height adjustment of steering wheel. |
t
| Technical data apply for the unladen weight of the vehicle ready for driving (full fuel tank and water reservoir for the windscreen wiper washer system, spare wheel and jack (if the vehicle was fitted at the factory with them), tool kit and without driver). The spare wheel, tool kit and jack must be located in the position prescribed by the vehicle manufacturer. |
Note If the corresponding unladen weight cannot be achieved (e.g. a vehicle with a tyre repair set or a vehicle with a fuel tank which is not completely full), the vehicle load must be set as follows: |
–
| Load the vehicle with a corresponding weight. |
–
| Determine the fuel volume in the fuel tank on the fuel gauge. |
–
| Place a weight above the fuel tank according to the following table: |
|
|
|