Octavia Mk2
Assembly overview of covers and upholstery for rear backrests |
1 - | Cover for side upholstery on the right |
2 - | Clamping section |
3 - | Cover |
4 - | Cover for the middle safety belt |
5 - | Plastic frame for armrest |
6 - | Guide |
7 - | Headrest |
8 - | Cover for side upholstery on the left |
9 - | Foam padding for side upholstery |
10 - | Cover |
Removing: |
l | Headrests are removed. |
– | Remove rear seat backrest → Chapter. |
– | Remove plastic frame for armrest (Pos. 5). |
– | Remove covers (Pos. 3 and Pos. 4). |
– | Unhook clamping section (Pos. 2) on the rear side of the backrest. |
– | Cut through the retaining clips (Pos. 18). |
– | Remove cover from backrest. |
Installing: |
– | Installation is carried out in the reverse order. |
Note
When installing the cover, use upholstery clip pliers e.g. -V.A.G 1634-. |
11 - | Foam padding |
q | Remove from the rear panel. |
12 - | Left rear panel |
13 - | Right rear panel |
14 - | Wire |
q | Sewn into foam padding. |
15 - | Plug connection |
(if present) |
16 - | Heating element |
(if present) |
17 - | Strut |
q | Sewn to cover (Pos. 10). |
q | With holes for inserting the retaining clips (Pos. 18). |
18 - | Clamp |
q | When removing cut through with pliers |
q | To install use upholstery pliers e.g. -V.A.G 1634-. |
19 - | Armrest |
q | Removing and installing → Chapter. |