skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Cleaning the water drain hoses > < Setting the parallel running

Octavia Mk2

Removing and installing assembly unit
Removing and installing assembly unit
  Note
Removal and installation of the assembly unit is carried out by 2 mechanics.
Removing
–  Removing the rotary switch of the automatic preselection mechanism → Chapter.
–  Remove the moulded headliner → Chapter.
   
–  Pull off water drain hoses -arrows- from assembly unit -1-.
  Note
The E-drive -3- must not be removed from the assembly unit -1-.
–  Screw out screws -2- and remove the assembly unit from the vehicle.
Install
  S60-0041
–  Insert assembly unit -1- in the roof.
–  Align the assembly unit -1- in the roof frame and secure with screws -2-. Follow the specified order for tightening the screws. Tightening torque: 8 Nm.
–  When tightening the screws -2- of the E-drive -3- proceed towards rear.
–  Fitting water drain hoses -arrows-.
–  Install the moulded headliner → Chapter.
–  Install the rotary switch for the automatic preselection mechanism → Chapter.
  S60-0041

Cleaning the water drain hoses > < Setting the parallel running