Checking the master brake cylinder for tightness |
Special tools and workshop equipment required |
t
| Brake system tester e. g. -V.A.G 1310 A- |
t
| Adapter M 10 e.g. -V.A.G 1310/6- |
l
| The function and tightness of the brake system (brake lines, brake hoses, brake calipers, hydraulic unit) are O.K. |
–
| Release the bleeder screw on one of the front brake calipers. |
–
| Connect the brake system tester e.g. - V.A.G 1310 A- to the brake caliper and bleed. |
–
| Push down brake pedal until the pressure gauge indicates 5 MPa (50 bar). Throughout the test which lasts 45 s the pressure loss must not exceed 0.4 MPa (4 bar). In case of high pressure loss replace the master brake cylinder. |
–
| Separate brake system tester e.g. - V.A.G 1310 A-. |
–
| Screw the bleeder screw into the brake caliper and bleed the brake caliper. |
|
|
|