Octavia Mk2
| Charge air system - Summary of components |
Note| t | On this engine, the charge-air cooler is located in the intake mainfold and is not cooled through air yet through water → Chapter. |
| t | The additional radiator for coolant of charge air system which is necessary for this, is located as previously in the lock carrier and is cooled through air. |
| 1 - | Additional radiator for coolant of charge air system |
| q | with top and bottom sealing strips |
| q | removing and installing → Chapter |
| 2 - | O-ring |
| q | replace if damaged |
| 3 - | Top coolant hose |
| q | connection diagram for coolant hoses → Chapter |
| 4 - | Spring strap clamp |
| q | use spring strap clips, e.g. -VAS 6340-, for removing and installing |
| 5 - | Connecting pipe |
| 6 - | Coolant hose |
| q | to the expansion reservoir |
| 7 - | Grommet |
| 8 - | Coolant hose |
| q | to exhaust gas turbocharger |
| 9 - | Coolant hose |
| 10 - | Intake manifold |
| q | removing and installing → Chapter |
| 11 - | Gasket |
| q | replace if damaged |
| 12 - | Seal |
| q | pay attention to correct seating when installing the charge air cooler |
| 13 - | Charge air cooler |
| q | to remove take off intake manifold → Chapter |
| 14 - | 7 Nm |
| q | when installing first tighten evenly by hand, then tighten to tightening torque |
| 15 - | Connecting pipe |
| 16 - | Coolant hose |
| q | connection diagram for coolant hoses → Chapter |
| 17 - | Coolant hose |
| q | connection diagram for coolant hoses → Chapter |
| 18 - | 8 Nm |
| 19 - | 8 Nm |
| 20 - | Coolant recirculation pump -V50- |
| q | removing and installing → Chapter |
| 21 - | Support |
| 22 - | 20 Nm |
| 23 - | Coolant pipe |
| 24 - | 8 Nm |
| 25 - | Bottom coolant hose |
| 26 - | 7 Nm |
| 27 - | Bearings |
| q | for additional radiator for coolant of charge air system |
