skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Engine control unit > < Removing and installing the unit injector (Superb II, Octavia II, Fabia II, Roomster)|Install

Octavia Mk2

Removing and installing the engine speed sender G28 (Superb II, Octavia II, Fabia II, Roomster)
Removing and installing the engine speed sender -G28- (Superb II, Octavia II, Fabia II, Roomster)
Special tools and workshop equipment required
t  Hose clamps up to Ø 25 mm -MP7-602 (3094) -
t  Assembly device -T10118-
Removing
–  Remove the sound dampening system → Body Work; Rep. Gr.50.
–  Unclip the coolant hoses at the oil cooler with hose clamps and remove the coolant hoses.
–  Remove oil filter holder Superb II and Octavia II → Chapter, Fabia II and Roomster → Chapter.
   
–  Disconnect plug -arrow- at engine speed sender -G28- with assembly device -T10118 - and lay the electrical cable to the side.
  Note
To unlock the plug without using the assembly device -T10118-, the unlock button must be pressed at the plug using a screwdriver and at the same time unlock the unlock button with a thin wire hook.
  A23-0205
–  Unscrew the fixing screw -2- for the engine speed sender -G28--1-.
Install
Installation is performed in the reverse order, pay attention to the following points:
–  Install oil filter holder Superb II and Octavia II → Chapter, Fabia II and Roomster → Chapter.
Tightening torque
  A23-0209
ComponentNm
Engine speed sender -G28- on the flange5

   

Engine control unit > < Removing and installing the unit injector (Superb II, Octavia II, Fabia II, Roomster)|Install