Octavia Mk2
Repairing the unit injectors (Superb II, Octavia II, Fabia II, Roomster) |
t | Always replace gaskets and O-rings |
1 - | 20 Nm + torque a further 90° (1/4 turn) |
q | replace |
2 - | Valve-lever shaft |
q | with valve levers |
3 - | Counternut, 30 Nm |
4 - | Adjusting screw |
q | replace when installing a new unit injector and where wear marks are visible |
q | Grease the contact surface of the unit injector to the ball pin using grease -G 000 100- |
5 - | Ball pin |
q | replace |
6 - | The unit injector |
q | Check ball pins for wear marks and replace if necessary |
q | Grease the contact surface to the adjusting screw using grease -G 000 100- |
q | removing and installing → Chapter |
7 - | O-ring |
q | replace → Chapter |
8 - | O-ring |
q | replace → Chapter |
9 - | O-ring |
q | replace → Chapter |
10 - | Heat-protection seal |
q | replace |
11 - | Circlip |
12 - | Cylinder head |
13 - | Clamping pad |
14 - | 12 Nm + torque a further 270° (3/4 turn) |
q | replace |