skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing parts of the cooling system - Part 2 > < Inspecting thermostat for map-controlled engine cooling F265 , engine identification characters BLR, BLX, BLY

Octavia Mk2

Removing and installing coolant regulator housing
Removing and installing coolant regulator housing
Removing
–  Remove alternator → Electrical System; Rep. Gr.27.
Vehicles with engine identification characters BLR, BLX, BLY, BVX, BVY, BVZ
–  Remove coolant pipe → Chapter.
Vehicles with engine identification characters BWA
–  Remove coolant pipes → Chapter.
Continued for all vehicles
   
–  Remove coolant hose -2- from coolant regulator housing. To this end pull out retaining clips -1-.
Vehicles with engine identification characters BLR, BLX, BLY
  S19-0229
–  Disconnect the plug -arrow- from the thermostat for map-controlled engine cooling -F265-.
Continued for all vehicles
  S19-0267
–  Release screws -arrows- and remove the coolant regulator housing.
Install
–  Clean sealing surface for O-ring.
–  Replace O-ring and moisten with coolant.
–  Position the coolant regulator housing at the cylinder block and tighten the screws evenly to 15 Nm.
–  Further installation occurs in a similar way in reverse order to removal.
  N19-10115

Removing and installing parts of the cooling system - Part 2 > < Inspecting thermostat for map-controlled engine cooling F265 , engine identification characters BLR, BLX, BLY