skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Checking the coolant system for leaktightness > < Removing and installing bottom coolant pipe, engine identification characters BLR, BLX, BLY, BVX, BVY, BVZ

Octavia Mk2

Removing and installing the coolant pipes, engine identification character BWA
Removing and installing the coolant pipes, engine identification character BWA
Special tools and workshop equipment required
t  Pliers for spring strap clamps
Removing
–  Remove engine cover → Chapter.
–  Remove fan shroud with radiator fans → Chapter.
   
–  Disconnect plug from charge pressure sender -G31--3-.
–  Release screws -2- and -4-.
–  Slacken the clamp -1-, separate the quick coupling at the charge air cooler and remove the charge air pipe with the hose downwards.
–  Drain coolant → Chapter.
  M24-0566
–  Disconnect the plug connections -arrows-.
  N19-10111
–  Detach the coolant hoses from the coolant pipes -arrows-.
  N19-10112
–  Detach the hose -A- and release the screw -B-. Remove the front coolant pipe.
  N19-10113
–  Pull the plug -A- out of the holder.
–  Open the spring strap clamp -B- and pull off the coolant hose.
–  Cut through cable straps -arrow-.
–  Release screws -C-. Remove the rear coolant pipe.
Install
Installation is carried out in the reverse order.
–  Tighten the screws of the coolant pipes to 5 Nm.
–  Top up coolant → Chapter.
  S19-0262

Checking the coolant system for leaktightness > < Removing and installing bottom coolant pipe, engine identification characters BLR, BLX, BLY, BVX, BVY, BVZ