Octavia Mk2
| Summary of components - Engine identification character BWA |
| 1 - | 10 Nm |
| 2 - | Cylinder head cover |
| q | order of tightening → Fig. |
| 3 - | Gasket |
| q | replace if damaged or leaking |
| 4 - | Valve housing |
| 5 - | Oil-filling cover |
| 6 - | Gasket |
| q | replace if damaged or leaking |
| 7 - | 4 Nm |
| 8 - | Gasket for cylinder head cover |
| q | replace if damaged or leaking |
| 9 - | Vacuum pump |
| 10 - | Camshaft adjustment valve 1 -N205- |
| q | removing and installing → Chapter |
| 11 - | Sealing ring |
| q | replace |
| 12 - | Cable strap |
| 13 - | Sealing ring |
| q | replace if damaged or leaking |
| 14 - | Housing |
| 15 - | Gasket |
| q | replace |
| 16 - | Spherical head, 3.5 Nm |
| q | for engine cover |
| 17 - | Left lifting eye |
| 18 - | 25 Nm |
| 19 - | Pin screw, 10 Nm |
| q | for the intake manifold |
| 20 - | Separation plate |
| 21 - | Cylinder head gasket |
| q | replace |
| q | Replace cylinder head gasket → Chapter |
| q | Observe fitting position: Part number points to cylinder head |
| 22 - | Right lifting eye |
| q | for engine cover |
| 23 - | Hall sender -G40- |
| 24 - | Sealing ring |
| 25 - | Pin screw, 10 Nm |
| q | for the tensioning roller |
| 26 - | Cylinder head |
| q | removing and installing → Chapter |
| q | Inspecting the cylinder head for distortion → Fig. |
| 27 - | Pin screw, 20 Nm |
| q | for exhaust manifold |
| q | grease with hot bolt paste -G 052 112 A3- |
| 28 - | Washer |
| 29 - | Cylinder head bolt |
| q | replace |
| q | pay attention to sequence for loosening and tightening → Chapter |
| q | Tightening torque: → Chapter |
