Skoda Workshop Service and Repair Manuals > Octavia Mk2 > Drive unit | 2.0/110; 147 kW FSI Engine | Engine cylinder head, valve gear | Valve gear - part 2 | Removing and installing camshaft adjustment valve 1 N205 , Engine identification characters BLR, BLX, BLY, BVX, BVY, BVZ

Removing and installing camshaft adjustment valve 1N205, Engine identification characters BLR, BLX, BLY, BVX, BVY, BVZ

Removing and installing camshaft adjustment valve 1 -N205-, Engine identification characters BLR, BLX, BLY, BVX, BVY, BVZ

Special tools and workshop equipment required

t	TORX bit assortment, e. g. -V.A.G 1766-

t	Attachment ratchet 1/4", e.g. -VAS 6234-

t	Pliers for spring strap clamps

Removing

Note

Always replace seals and gasket rings.

–	Unplug connector -1-.

–	Release the screws -arrows- and pull the camshaft adjustment valve 1 -N205- out of the housing.

Installing

Note

t	The camshaft adjustment valve 1 -N205 - as well as the housing must be free of dirt and contaminations.

t	Remove the new camshaft adjustment valve 1 -N205- from the wrapping before installing.

Caution

The camshaft adjustment valve 1 -N205 - must not be subject to impacts or vibrations.

–	Moisten gasket ring with engine oil.

–	Carefully insert the camshaft adjustment valve 1 -N205 - into the housing and press it in fully by hand and without tilting it.

–	Tighten screws to 4 Nm.

Further installation occurs in a similar way in reverse order to removal.

Skoda Workshop Service and Repair Manuals