skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the toothed belt, engines without split toothed belt guard > < Disassembling and assembling engine - Part 2

Octavia Mk2

Removing and installing V-ribbed belt
Removing and installing V-ribbed belt
Special tools and workshop equipment required
t  Locking pin -T10060 A-
Removing
–  Remove the sound dampening system → Body Work; Rep. Gr.50.
Vehicles with engine identification characters BWA
–  Remove engine cover → Chapter.
Continued for all vehicles
   
–  Pull activated charcoal filter with its attached lines to the top in -direction of arrow- out of the bracket and place to the side.
–  Mark the rotation direction of the V-ribbed belt.
  S13-0587
–  Loosen the V-ribbed belt by swivelling the tensioning element in -the direction of the arrow-.
  S13-0586
–  Interlock the tensioning element with the locking pin -T10060 A-.
–  Remove the V-ribbed belt.
Installing
–  Installation is carried out in the reverse order. Pay attention to the following:
  Note
t  Pay attention to the correct position and rotation direction of the V-ribbed belt in the belt pulley when installing it.
t  On vehicles without air conditioning system, fit the V-ribbed belt last on the belt pulley for AC generator → Chapter.
t  On vehicles with air conditioning system, fit the V-ribbed belt last on the belt pulley for AC compressor → Chapter.
Each time work has been completed:
–  Start engine and check belt run.
  S13-0588

Removing and installing the toothed belt, engines without split toothed belt guard > < Disassembling and assembling engine - Part 2