skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the two-mass flywheel > < Removing and installing the sealing flange on the belt pulley side

Octavia Mk2

Replace sealing flange on the gearbox side
Replace sealing flange on the gearbox side
Special tools and workshop equipment required
   
t  Assembly device -T10122-
Removing
–  Remove the two-mass flywheel or the driver disc.
t  Remove two-mass flywheel: → Chapter
t  Remove the driver plate: → Chapter
–  Removing the oil pan → Chapter.
  W00-1234
–  Unscrew sealing flange -arrows-.
Install
  Note
t  Do not additionally lubricate or grease sealing lip of the gasket ring!
t  The sealing flange is seated on the dowel pins.
–  Clean the sealing surfaces. They must be free of oil and grease.
–  Remove oil residue on the crankshaft bearing pin with a clean cloth.
Sealing flange with supporting sleeve
–  Install sealing flange.
  Note
t  To install, use the supplied supporting sleeve.
t  The supporting sleeve must not be removed until after pushing the sealing flange onto the crankshaft bearing pin.
Sealing flange without supporting sleeve
–  Fit together assembly sleeves -T10122/1- and -T10122/2 -.
  S13-0607
–  Push the assembly sleeves onto the sealing flange -A- as shown.
–  Separate the assembly sleeves.
  N13-10127
–  Position the sealing flange -A- with the assembly sleeve -T10122/2- on the crankshaft and push the sealing flange onto the crankshaft bearing pin.
Complete installation
  N13-10126
–  Tighten fixing screws to 15 Nm -arrows-.
Further installation occurs in a similar way in reverse order to removal.
  S13-0607

Removing and installing the two-mass flywheel > < Removing and installing the sealing flange on the belt pulley side