skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Ignition system, glow plug system > < Check change-over for radiator for exhaust gas recirculation

Octavia Mk2

Removing and installing radiator for exhaust gas recirculation
Removing and installing radiator for exhaust gas recirculation
Special tools and workshop equipment required
t  Hose clamps up to Ø 25 mm -MP7-602 (3094)-
t  Catch pan for workshop crane, e.g. -VAS 6208-
t  Pliers for spring strap clamps
Removing
–  Remove diesel particle filter → Chapter.
   
–  Release nuts -2- and screws -3- and remove the connection pipe for exhaust gas recirculation.
–  Place a catch pan under the engine.
  A21-10153
–  Press together coolant hoses with hose clamps up to Ø 25 mm -3094- and remove from radiator for exhaust gas recirculation.
–  Remove heat shield collar from vacuum setting element.
  A26-10405
–  Release screw -2- and hollow screw -3-.
–  Turn the support for exhaust gas turbocharger by 90° and pull it towards the bottom out of the oil return-flow line.
  A21-10088
–  Release screws -1- for connection pipe for exhaust gas recirculation.
–  Remove vacuum hose -2- from vacuum setting element and expose.
–  Release screws -arrows- and remove radiator for exhaust gas recirculation.
Install
Installation occurs in reverse order to removal. Pay attention to the following:
t  Replace the gaskets, the sealing rings and the self-locking nuts.
t  Secure all hose connections with corresponding hose clips.
t  Tightening torques → Chapter and → Chapter.
–  Inspect coolant level and top up if necessary → Chapter.
  A26-10406

Ignition system, glow plug system > < Check change-over for radiator for exhaust gas recirculation