skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Exhaust turbocharger, G-charger > < Accelerator pedal module - Summary of components

Octavia Mk2

Removing and installing accelerator pedal module
Removing and installing accelerator pedal module
Special tools and workshop equipment required
t  Release tool -T10238- (for left-hand drive vehicle)
t  Release tool -T10240- (for right-hand drive vehicle)
Removing
   
–  Remove cover for the steering column -arrows-.
–  Lever out the cap ( → Chapter, position 4) with a screwdriver.
–  Unscrew the fixing screw ( → Chapter, position 3).
  S20-0134
–  Push the release tool -T10238- (on right-hand drive vehicles release tool -T10240-), as shown up to the stop into the provided openings and remove the accelerator pedal module.
–  Unplug connector from accelerator pedal module. To do so press down securing element from connector.
Install
  S20-0175
–  Fit connector -2- onto the accelerator pedal module -5-.
   The locking of the connector must be audible.
–  Push accelerator pedal module onto the fixing bolts -6-.
–  Insert centering pin -7- in the hole on the vehicle floor.
–  Fasten accelerator pedal module with screw -3- (10 Nm) and fit on cap -4-.
–  Re-install cover for steering column.
–  If the accelerator pedal module was replaced, the engine control unit has to be adapted → Vehicle diagnosis, testing and information system VAS 5051.
  S20-0270

Exhaust turbocharger, G-charger > < Accelerator pedal module - Summary of components