skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Connection diagram for vacuum hoses for exhaust gas recirculation system for engine with engine identification characters BMM > < Checking change-over for radiator for exhaust gas recirculation for engine with engine identification characters BMM

Octavia Mk2

Removing and installing radiator for exhaust gas recirculation for engine with engine identification characters BMM
Removing and installing radiator for exhaust gas recirculation for engine with engine identification characters BMM
Special tools and workshop equipment required
t  Catch pan for workshop crane, e.g. -VAS 6208-
t  Pliers for spring strap clamps
–  Remove pre-exhaust pipe with diesel particle filter → Chapter.
–  Drain coolant → Chapter.
Vehicles with four-wheel drive
–  Remove right flange shaft for angle gearbox → Gearbox → Rep. Gr.39.
Continued for all vehicles
–  Place a catch pan under the engine.
–  Detach coolant hoses from radiator for exhaust gas recirculation.
   
–  Unscrew connection pipe for exhaust gas recirculation radiator -arrows-.
  A26-10191
–  Release screw -2- and hollow screw -3-.
–  Turn the support for exhaust gas turbocharger by 90° and pull it towards the bottom out of the oil return-flow line.
  A21-10088
–  Unbolt bracket -2- for diesel particle filter.
–  Disconnect the vacuum line -1- and remove.
–  Release screws -arrows- and remove radiator for exhaust gas recirculation.
Install
Installation occurs in reverse order to removal. Pay attention to the following:
  Note
t  Replace the gaskets and the self-locking nuts.
t  Secure all hose connections with corresponding hose clips.
  A26-10192

Connection diagram for vacuum hoses for exhaust gas recirculation system for engine with engine identification characters BMM > < Checking change-over for radiator for exhaust gas recirculation for engine with engine identification characters BMM