Octavia Mk2
Intake manifold - Summary of components for engine with engine identification characters BMM |
1 - | Gasket |
q | replace |
2 - | Intake manifold |
3 - | Gasket ring |
q | replace |
4 - | Supports |
5 - | Intake manifold flap motor -V157- |
q | The intake manifold flap is closed for about 3 seconds after switching off the engine and then opens again. This reduces the switch-off impact. |
6 - | from charge-air cooler |
7 - | 10 Nm |
8 - | electrical exhaust gas recirculation valve -N18- with EGR potentiometer -G212- and EGR control motor -V338- |
q | before installing, check sealing surfaces at intake manifold for dirt and clean as required |
q | After replacing, adapt new part as follows: |
– | Switch ignition on and off and wait 1 minute for the afterrun of the control units. |
– | Start engine and run in idle for at least 1 minute. |
– | Interrogate the fault memory → Vehicle diagnosis, testing and information system VAS 5051. |
l | No fault must be stored in the fault memory. |
– | If a fault occurs, erase the fault memory and repeat the entire work procedure. |
9 - | Gasket |
q | replace |
10 - | Radiator |
q | for exhaust gas recirculation |
11 - | 22 Nm |
12 - | Support |
13 - | 22 Nm |