skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Disassembling and assembling (Climatronic) the air conditioning unit > < Climatronic - Air conditioner with automatic regulation - Part 2
Summary of components
   
Summary of components
Check condensation water drain → Chapter.
1 - Dash panel
q   removing and installing → Body Work → Rep. gr.70
2 - Sunlight penetration photosensor -G107 - and Sunlight penetration photosensor 2 - G134-
q   fitted together in one housing
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   Function:depending on the intensity of the sunlight controls the left and right temperature flap and the fresh air blower
q   Emergency operation in the event of failure: Climatronic control unit -J255- adopts fixed value
q   removing and installing → Chapter
3 - Air quality sensor -G238-
q   mounted as of CW 22.09
q   Description, removing and installing → Chapter
4 - Intake air grid
q   removing and installing → Chapter
5 - Centre vent
q   removing and installing → Chapter
6 - Outer dash panel vent
q   removing and installing → Chapter
7 - Right footwell vent
q   removing and installing → Chapter
8 - Shield for air conditioning unit
q   removing and installing → Chapter
9 - Dust and pollen filter
q   removing and installing → Chapter
10 - Rear duct of right footwell
q   removing and installing → Chapter
11 - Center rear duct
q   removing and installing → Body Work → Rep. gr.68
12 - Center rear vent
q   removing and installing → Chapter
13 - Air deflector
q   for center rear vent
14 - Rear duct of left footwell
q   removing and installing → Chapter
15 - Evaporator vent temperature sender -G263-
q   removing and installing → Chapter
16 - Right temperature flap control motor -V159-
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   removing and installing → Chapter
17 - Heating element for air auxiliary heating -Z35-
q   removing and installing → Chapter
18 - Heat exchanger
q   removing and installing → Chapter
q   replace coolant after changing the heat exchanger
19 - Left footwell vent
q   removing and installing → Chapter
20 - Left temperature flap control motor -V158-
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   removing and installing → Chapter
21 - Left footwell vent temperature sender -G261-
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   removing and installing → Chapter
22 - Defroster flap control motor -V107-
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   removing and installing → Chapter
23 - Air conditioning unit
q   removing and installing → Chapter
q   disassembling and assembling → Chapter
24 - Control motor of centre flap -V70-
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   removing and installing → Chapter
25 - Vent duct
q   for window blower in the door
q   Part of the cover
26 - Intermediate piece for defroster duct
q   placed onto the distributor housing and secured with a clip on the cross member - dash panel
q   for removing, take out dash panel
27 - Left vent temperature sender -G150-
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   removing and installing → Chapter
28 - Intermediate piece for dash panel vents
q   placed onto the distributor housing
q   for removing, take out dash panel
29 - Right vent temperature sender -G151-
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   removing and installing → Chapter
30 - Re-circulating air flap control motor -V113-
q   Mounted up to 05.07. As of 06.07, its function is replaced by the control motor of air flow flap and re-circulating air flap -V71-
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   removing and installing → Chapter
31 - Fresh air intake duct temperature sensor -G89-
q   only on vehicles manufactured up to 05.05.
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   Function: the temperature sensor controls the temperature flap and the fresh air blower according to the temperature
q   In case of signal failure, the value from the ambient temperature sensor -G17- is used.
q   to disassemble, remove dash panel, turn temperature sensor by 90°, remove and disconnect plug connection.
32 - Vehicles up to 05.07: air flow flap control motor -V71-, vehicles as of 06.07: air flow flap control motor and re-circulating air flap -V71-
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   removing and installing → Chapter
33 - Fresh air blower -V2- with fresh air blower control unit -J126-
q   Removing and installing fresh air blower → Chapter
q   the control unit cannot be replaced individually
34 - Climatronic control unit -J255-
q   The Climatronic control unit -J255 - and the Control and display unit for air conditioner, Climatronic -E87- cannot be disassembled.
q   As of MY 09, different arrangement of actuating elements and displays
q   Description of the function → Chapter
q   inspect → Vehicle diagnostic tester in the function „Targeted fault finding“
q   removing and installing → Chapter

   

Disassembling and assembling (Climatronic) the air conditioning unit > < Climatronic - Air conditioner with automatic regulation - Part 2