Octavia Mk2
|
| 1 - | Cover for auxiliary heating control unit -J364- |
| q | removing - separate the fuel supply and unlatch the cover from the latch clips |
| 2 - | Temperature sensor -G18- |
| q | remove and install, test → Chapter |
| 3 - | Overheating sensor -G189- |
| q | remove and install, test → Chapter |
| 4 - | Fuel shut-off valve -N109- |
| q | only on vehicles with diesel engine as of CW 45.05 |
| q | Component of the combustion pipe, cannot be replaced individually |
| q | Inspect proper operation → Chapter |
| 5 - | Combustion pipe |
| 6 - | Heat exchanger |
| 7 - | 7 Nm |
| 8 - | Retaining spring |
| 9 - | 4 Nm |
| 10 - | Gasket |
| q | replace after each removal |
| q | Check fitting position |
| 11 - | Cover |
| q | removing and installing → Chapter |
| 12 - | Coolant hose supports |
| 13 - | 4 Nm |
| 14 - | Retaining plate |
| 15 - | Coolant hose supports |
| 16 - | Retaining clip |
| 17 - | Glow plug with flame monitoring -Q8- |
| q | pay attention to correct position |
| q | remove and install, test → Chapter |
Note| For vehicles with diesel engines, the heating element for fuel preheating -Z66- is installed firmly at the combustion pipe The cables are connected with the cables of the glow plug with flame monitoring -Q8-. In the case of this version the complete combustion pipe must be replaced, if the glow plug with flame monitoring -Q8- is defective. |
| 18 - | Heating element for fuel preheating -Z66- (only diesel engines) |
| q | Inspect proper operation → Vehicle diagnostic tester |
| 19 - | Housing |
| q | the combustion air blower -V6- and the housing cannot be disassembled |
| 20 - | Auxiliary heating control unit -J364- |
| q | removing and installing → Chapter |
| 21 - | 4 Nm |