Skoda Workshop Service and Repair Manuals

Removing Vehicles Octavia II and Superb II –  Remove angle gearbox → Chapter.

–  Screw angle gearbox on gearbox mount -T30097-.    A - Place nut M12 x 10 (8 pieces) between angle gearbox and gearbox mount -T30097-. Vehicles Yeti –  Remove gearbox together with angle gearbox → Chapter. –  Separate angle gearbox from gearbox → Chapter.

–  Position angle gearbox onto the opening -arrow- marked with the number -4- in the gearbox mount -T30097 -. –  Then align the angle gearbox opposite the remaining 3 openings and fasten.    -A- Place nut M12 x 10 (4 pieces) between angle gearbox and gearbox mount.   Note

The angle gearbox can also be attached to the gearbox mount -T30012 (3221)-. To do so, place 8 nuts -A- M12 x 10 between angle gearbox and gearbox mount. Continued for all vehicles –  Position the catch pan under the angle gearbox.

–  Remove oil drain plug -A- from angle gearbox. –  Drain oil out of angle gearbox. –  Install oil drain plug -A- and tighten to tightening torque.

–  Lock the output flange for angle gearbox with bracket -T30097/1- and two screws M10 x 30 -arrows-. Vehicles Yeti   Note Use the stop plate -T30012/1A (3221/1A)- for the gearbox mount -T30012 (3221)-. Continued for all vehicles –  Unscrew nut for output flange (always replace nut → Electronic Catalogue of Original Parts).    A - socket wrench insert SW 36

–  Detach output flange with three armed extractor-A- and thrust plate -MP3-467-.    A - Three armed extractor e.g. -Kukko 45-2-   Note When pulling off the output flange the inner ring/tapered-roller bearing remains on the output flange and must be removed from it.

–  Remove inner ring/tapered-roller bearing with tapered-roller bearing extractor -V.A.G 1582- and gripper -V.A.G 1582/1- from output flange.   Note Instead of the gripper -V.A.G 1582/1- it is also possible to use the gripper -V.A.G 1582/1 A-. –  Pull out seal ring for angle gearbox output flange with Multi-purpose tool -MP3-419-. –  Clean the thread at the shank bevel gear, for the securing nut of the output flange, to remove locking agent residues.