| Change the gearbox oil and filter of the automatic gearbox DSG and at the same time check the oil level |
| Change the gearbox oil, replace the oil filter → Chapter. |
| Special tools and workshop equipment required |
| t
| Vehicle Diagnosis, Measurement and Information System -VAS - |
| t
| Adapter for oil filling -VAS 6262- or -VAS 6262A- |
| t
| Adapter for oil filling -VAS 6262/2- |
| t
| Pliers for spring strap clips, e.g. -VAS 6340- |
Caution | t
| When changing the gear oil, the gearbox oil filter must not always be replaced. Therefore comply with the instructions, when the gearbox oil filter must be replaced and when not → Chapter. |
| t
| The engine must not be started if the repair was carried out and no oil was poured in, or only a small amount of oil is available in the gearbox, or after a major gearbox oil loss. |
| t
| Only gear oil for the double clutch gearbox must be used, which is indicated as spare part for automatic gearbox DSG - 02E. Other oils can lead to functional problems or to failure of the gearbox, part number → Electronic catalogue of original parts. |
|
Note | t
| Observe instructions for automatic gearbox DSG - 02E → Chapter. |
| t
| Regulations concerning cleanliness when working on the gearbox → Chapter. |
| t
| The gear oil level changes with the gearbox oil temperature. |
| t
| Checking gear oil level when oil temperature is too low may result in over-filling. |
| t
| Checking gear oil level when oil temperature is too high may result in under-filling. |
| t
| An over-filling as well as an under-filling impairs the proper working of the gearbox. |
| l
| Vehicle in horizontal position; all supports of the lift platform must be at the same level, so that it is secured in the horizontal position. |
| l
| Vehicle diagnosis, measurement and information system VAS is connected. |
| l
| The gearbox oil temperature must not exceed 35°C at the start of the test. |
Note |
|
|
