| If the clamping screw -arrow- is released, the selector lever must remain in position „P“, otherwise the setting is not correct. |
| –
| Slightly move the selector lever towards the front and rear, without shifting into another selector lever position. |
| –
| Tighten clamping screw -arrow- at selector lever cable without jolting to tightening torque. |
| t
| up to 11.08 tightening torque 13 Nm |
| t
| as of 12.08 tightening torque 12 Nm |
Note | Pay attention when tightening the clamping screw -arrow- that the selector lever control cable no longer shifts. |
| This completes the setting. |
| Inspect setting of selector lever control cable |
| –
| Pull selector lever out of position „P“ with the button pressed, approx. 5 mm to the rear and hold, do not shift into position „R“. |
| –
| Release the selector lever. |
| l
| The selector lever must automatically jump back again into the position „P“. |
| –
| If necessary adjust the selector lever → Anchor. |
| –
| Shift selector lever to position „N“. |
| –
| Pull selector lever out of position „N“ with the button pressed, approx. 5 mm to the rear and hold, do not shift into position „D“. |
| –
| Release the selector lever. |
| l
| The selector lever must automatically jump back again into the position „N“. |
| –
| If necessary adjust the selector lever → Anchor. |
| –
| Pull selector lever out of position „N“ with the button pressed, approx. 5 mm to the front and hold, do not shift into position „R“. |
| –
| Release the selector lever. |
| l
| The selector lever must automatically jump back again into the position „N“. |
| –
| If necessary adjust the selector lever → Anchor. |
|
|
|
