skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing gasket ring for flange shaft|Install > < Removing and installing gasket ring for flange shaft

Octavia Mk2

Removing
Removing
The removal of the gasket ring is identical on both left and right.
–  Remove drive shaft → Chassis; Rep. gr.42
–  Place a catch pan under the rear final drive.
Remove the left flange shaft
   
–  Manually screw the plate -1- of the extractor -T10037- with two screws M8 (30 mm long) onto the flange shaft.
l  The shoulders -arrows- for larger flange diameters point to the outside.
–  Position the nut of the knurled screw -2- from the extractor -T10037- onto the hexagon screw -3-.
–  Pull out the flange shaft with extractor -T10037-.
Removing the right flange shaft
–  Manually screw the plate of the extractor -T10037- with two screws M8 (30 mm long) onto the flange shaft.
l  The shoulders for larger flange diameters point to the outside.
  S39-0409
–  Fit the nut of the knurled screw -arrow- of the extractor -T10037- in such a way that the start of the thread is aligned with the housing.
–  Pull out the flange shaft with extractor -T10037-.
Proceed as follows for both sides
  S39-0333
–  Pull out seal ring for flange shaft with ejection lever -MP3-418-.
  S39-0335

Removing and installing gasket ring for flange shaft|Install > < Removing and installing gasket ring for flange shaft