skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing gasket ring for right flange shaft (vehicles with front-wheel drive) > < Removing

Octavia Mk2

Install
Install
   
–  Drive the new seal ring in up to the stop, do not twist the seal ring.
–  Fill half the space between the sealing lip and dust lip with sealing grease -G 052 128 A1-.
–  Replace the O-ring on the rigid shaft.
–  Insert rigid shaft.
–  Secure the rigid shaft with the conical screw and tighten to the recommended tightening torque.
–  Grease the spline on the rigid shaft with grease for plug serration of clutch disc -G 000 100-.
  N39-10001
–  Guide the intermediate shaft -B- through the bracket -C- onto the rigid shaft of the gearbox.
–  Tighten intermediate shaft to bracket -arrows- → Chassis; Rep. gr.40.
–  Install right drive shaft -A- → Chassis; Rep. gr.40.
–  Check gear oil level → Chapter.
–  Install the noise insulation → Body Work; Rep. gr.50.
  N39-10000
Tightening torque
ComponentNm
Rigid shaft on gearbox (conical screw) → Chapter

   

Replacing gasket ring for right flange shaft (vehicles with front-wheel drive) > < Removing