skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing gasket rings between angle gearbox and manual gearbox (four-wheel drive) > < Removing

Octavia Mk2

Install
Install
–  Lightly oil new gasket ring at outer surface.
   
–  Drive in the new gasket ring with thrust piece -T10049- up to the stop, do not twist the new gasket ring.
–  Fill half the space between the sealing lip and dust lip with sealing grease -G 052 128 A1-.
–  Carefully drive in flange shaft (slowly turn flange shaft).
  N39-0764
–  Tighten the screw of the flange shaft -arrow 1- with socket insert -T10107A-.
–  Install right drive shaft → Chassis; Rep. gr.40
–  After installing the right flange shaft, check the oil level in the angle gearbox → Chapter, to do so unscrew the oil filler plug -B-.
–  On vehicles with particle filter install the bracket for the particle filter, if it was removed → Engine; Rep. gr.26.
  S34-1047
–  Install heat shield for drive shaft -arrows-, if it was removed.
  A10-10260
Vehicles with auxiliary heating.
–  On these vehicles, fit the coolant pipes -B- onto the double screws at the angle gearbox and install on the engine -arrow 2-.
For all vehicles
–  Install the front right wheelhouse liner → Body Work; Rep. gr.66
–  Install the noise insulation → Body Work; Rep. gr.50.
–  Attach the right front wheel → Chassis; Rep. gr.44.
  S34-1238
Tightening torques
ComponentNm
Flange shaft on gearbox (conical screw) → Chapter
Heat shield of drive shaft to angle gearbox → Chapter

   

Replacing gasket rings between angle gearbox and manual gearbox (four-wheel drive) > < Removing