skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing the angle gearbox output flange gasket ring (four-wheel drive)|Install > < Replacing the angle gearbox output flange gasket ring (four-wheel drive)

Octavia Mk2

Removing
Removing
–  Remove angle gearbox → Chapter
   
–  Screw angle gearbox on gearbox mount -T30097-.
   A - Place nut M12 x 10 (8 pieces) between angle gearbox and gearbox mount -T30097-.
–  Position the catch pan under the angle gearbox.
  S39-0378
–  Remove oil drain plug -A- from angle gearbox.
–  Drain oil out of angle gearbox.
–  Install oil drain plug -A- and tighten to tightening torque.
  S34-1047
–  Lock the output flange for angle gearbox with bracket -T30097/1- and two screws M10 x 30 -arrows-.
–  Unscrew nut for output flange (always replace nut → Electronic Catalogue of Original Parts).
   A - socket wrench insert SW 36
  S39-0379
–  Detach output flange with three armed extractor -A- and thrust plate -MP3-467 (40-105)-.
   A - Three armed extractor, e.g. -Kukko 45/2-
  Note
When pulling off the output flange the inner ring/tapered-roller bearing remains on the output flange and must be removed from it.
  S39-0380
–  Remove inner ring/tapered-roller bearing with tapered-roller bearing extractor -V.A.G 1582- and gripper -V.A.G 1582/6- from output flange.
–  Pull out seal ring for angle gearbox output flange with Multi-purpose tool -MP3-419 (VW 771)-.
  A39-0297

Replacing the angle gearbox output flange gasket ring (four-wheel drive)|Install > < Replacing the angle gearbox output flange gasket ring (four-wheel drive)