skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing the angle gearbox output flange gasket ring (four-wheel drive) > < Removing

Octavia Mk2

Install
Install
–  The installation occurs in reverse order, while paying attention to the following.
   
–  Moisten gasket ring -2- with gear oil.
–  Insert gasket ring -A- into the slot -arrow-.
–  Install assembly device -T10047- → Anchor.
  N39-10211
–  In order to avoid damaging the contact surface of the bearing on the shaft, turn the shaft during the pressing procedure -arrow-.
–  Secure bearing with new circlip → Electronic Catalogue of Original Parts.
–  Carefully drive on flange shaft (slowly turn flange shaft).
–  Secure the flange shaft with the conical screw and tighten with tightening torque.
–  Bolt drive shaft to flange shaft → Chassis; Rep. gr.40.
  S39-0122
–  Install cap for drive shaft -arrows-, if it was removed.
–  Inspecting oil level in the angle gearbox → Chapter.
–  Install the front right wheelhouse liner → Body Work; Rep. gr.66.
–  Install the noise insulation → Body Work; Rep. gr.50.
–  Attach the right front wheel → Chassis; Rep. gr.44.
  A10-10260
Tightening torque
Flange shaft on gearbox (conical screw) → Chapter
Protective cap drive shaft on angle gearbox → Chapter

   

Replacing the angle gearbox output flange gasket ring (four-wheel drive) > < Removing