skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Removing and installing over-centre helper spring (Octavia II) > < Overview
Summary of components - Foot controls
   
Summary of components - Foot controls
1 - Front wall
q   with mount for bracket
2 - Gasket
q   replace → Electronic Catalogue of Original Parts
q   between bracket and front wall
q   self-adhesive
q   glue to bracket
3 - Bearing bracket
q   for support of clutch pedal
q   removing and installing (Octavia II) → Chapter
q   removing and installing (Superb II) → Chapter
q   removing and installing (Yeti) → Chapter
4 - Screw
5 - Over-centre helper spring
q   removing and installing (Octavia II) → Chapter
q   removing and installing (Superb II) → Chapter
q   removing and installing (Yeti) → Chapter
6 - Bushing
7 - Bearing bolt
8 - Clutch pedal
q   removing and installing (Octavia II) → Chapter
q   removing and installing (Superb II) → Chapter
q   removing and installing (Yeti) → Chapter
9 - Support
q   removing and installing (Octavia II) → Chapter
q   removing and installing (Superb II) → Chapter
q   removing and installing (Yeti) → Chapter
10 - Gasket
q   replace → Electronic Catalogue of Original Parts
q   between master cylinder and bracket
11 - Master cylinder
q   removing and installing after removing the bracket (Octavia II) → Chapter
q   removing and installing after removing the bracket (Superb II) → Chapter
q   removing and installing after removing the bracket (Yeti) → Chapter
q   test tightness → Chapter
12 - Clutch position sender -G476-
q   removing and installing (Octavia II) → Chapter
q   removing and installing (Superb II) → Chapter
q   removing and installing (Yeti) → Chapter
q   check → Vehicle diagnostic tester
13 - Clamp
q   to remove and install the tube-hose line pull out retaining clip up to the stop
14 - Tubing
q   Plastic return hose → Chapter
q   Do not use hose clamp -MP7–602-
q   test tightness → Chapter
15 - 20 Nm
q   3 pieces
q   self-locking
q   for bracket on front wall
q   replace → Electronic Catalogue of Original Parts
16 - 25 Nm
q   replace → Electronic Catalogue of Original Parts
17 - Stop
q   for the clutch pedal

   

Removing and installing over-centre helper spring (Octavia II) > < Overview