skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Mixture preparation system, electronic inj.,Gas > < Activated charcoal container system - Summary of components
Check fuel tank ventilation
Check fuel tank ventilation
Special tools and workshop equipment required
t  Hand vacuum pump, e.g. -VAS 6213-
t  Adapter set, e.g. - V.A.G 1318/17A-
t  Adapter, e.g. -V.A.G 1318/20-1-
  Note
t  The adapter set -V.A.G 1318/17A- replaces the adapter set -V.A.G 1318/17 -.
t  The figures shown in the description were not changed for this reason.
Test condition
l  The ignition must be switched off.
Test sequence
   
–  Detach vent line -1-. To do so press in the securing ring.
  S10-0213
–  Put the control ring -1- of the hand vacuum pump -VAS 6213- in position -A- for „pressure“.
  N24-10282
–  Then connect the hand vacuum pump -VAS 6213--1- on the vent line -2- as shown in the figure.
–  Operate the hand vacuum pump -VAS 6213- several times.
l  No vacuum should build up.
If a vacuum builds up.
–  Check the air admission fitting on the activated charcoal filter for dirt and clean as required.
If no vacuum builds up:
  N20-10238
–  Shut off air admission fitting -arrow- and once again operate the hand vacuum pump several times.
l  A vacuum should build up.
If no vacuum builds up:
–  Replace activated charcoal filter.
  N20-10239

Mixture preparation system, electronic inj.,Gas > < Activated charcoal container system - Summary of components