Octavia Mk2
| Summary of components - Vehicles without air conditioning |
| 1 - | V-ribbed belt |
| q | Routing of the ribbed V-belt → Fig. |
| q | mark the direction of rotation with chalk or a felt-tip pen before removing |
| q | check for wear |
| q | do not kink |
| q | removing and installing → Chapter |
| 2 - | Fixing screw |
| q | for crankshaft - belt pulley |
| q | replace |
| q | The clamping surface of the fixing screw must be free of grease and oil. |
| q | insert oiled (thread) |
| q | tighten → Chapter |
| 3 - | Crankshaft-belt pulley |
| q | Clamping surfaces must be free of oil and grease. |
| 4 - | Diamond coated washer |
| q | diamond coated washer pressed onto the belt pulley |
| q | replace if damaged |
| 5 - | 20 Nm |
| q | When loosening and tightening, counterhold with the wrench for the water pump and power-assisted steering -MP 1-308 (V.A.G 1590)- to this end rework wrench for the water pump and power-assisted steering -MP 1-308 (V.A.G 1590)- → Chapter |
| 6 - | Belt pulley for coolant pump |
| q | removing and installing → Chapter |
| 7 - | 9 Nm |
| 8 - | Vacuum hose |
| q | to solenoid valve for coolant circuit -N492- at intake manifold |
| 9 - | Coolant pump |
| q | removing and installing → Chapter |
| 10 - | 25 Nm |
| 11 - | AC generator |
| q | removing and installing → Electrical System; Rep. gr.27 |
| q | to facilitate the positioning of the AC generator drive the threaded bushings on the generator slightly backwards |
| 12 - | Bracket for auxiliary units |
| q | for the tensioning device |
| q | removing and installing → Chapter |
| 13 - | 40 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 14 - | 25 Nm |
| 15 - | Tensioning device for V-ribbed belt |
| q | swivel tensioning device for V-ribbed belt with wrench to slacken the V-ribbed belt |
| q | Secure the tensioning device with a 4 mm hexagon wrench or a locating pin -T10060 A- |
| q | to remove, release screw Pos. 12 |
|
|
