skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing intake manifold > < Intake manifold with component parts - Summary of components

Octavia Mk2

Removing and installing the throttle valve control unitJ338
Removing and installing the throttle valve control unit -J338-
Removing
–  Remove engine cover → Chapter.
–  Remove the sound dampening system → Body Work; Rep. gr.50.
   
–  Remove the charge air hose, to do so slacken the screw clamps -1 and 2-.
  A21-10489
–  Release screws -arrows-.
–  Expose coolant hose -3-.
–  Loosen hose clamp -2-.
–  Disconnect the plug -1- at the charge pressure sender -G31-/intake air temperature sender -G42- and remove the right charge air pipe.
  A21-10435
–  Disconnect the plug -2- from the throttle valve control unit -J338-.
–  Release screw -1- of guide pipe for oil dipstick.
–  Release screws -arrows- and remove throttle valve control unit -J338-.
Install
Installation is performed in the reverse order, pay attention to the following points:
l  Tightening torques → Chapter.
  Note
Replace O-ring.
  A23-10448

Removing and installing intake manifold > < Intake manifold with component parts - Summary of components