skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replace coolant temperature sender at radiator outletG83 > < Remove and install coolant recirculation pump 2V178

Octavia Mk2

Replace coolant temperature senderG62
Replace coolant temperature sender -G62-
Precondition
l  Engine is cold
–  Briefly open the cap for the coolant expansion reservoir in order to adjust the pressure in the coolant system.
–  Remove engine cover → Chapter.
–  Remove air filter → Chapter.
–  Remove the sound dampening system → Body Work; Rep. gr.50.
   
–  Screw out screws -arrows- and screw -5-.
–  Expose electrical cables and hoses on the left charge air pipe.
–  Release hose clamp -3- and push charge air pipe to the side.
  A21-10493
–  Disconnect plug -2- at the coolant temperature sender -G62-.
  Note
t  In order to collect flowing out coolant, place a cloth below the connection fitting.
t  Have a new coolant temperature sender -G62- with a new gasket ring ready.
–  Remove the retaining clip -1-, pull the coolant temperature sender -G62- out of the connection fitting and install a new coolant temperature sender -G62-.
Further installation occurs in reverse order to removal.
–  Inspect coolant level, top up with coolant if necessary → Chapter.
  S19-0319

Replace coolant temperature sender at radiator outletG83 > < Remove and install coolant recirculation pump 2V178