Octavia Mk2
Fuel tank with component parts - Summary of components Octavia II with front-wheel drive |
1 - | Mounting part |
2 - | Screw cap |
q | replace the O-ring if it is damaged |
3 - | Earth connection |
q | check for firm seating |
4 - | 11 Nm |
5 - | Guide |
6 - | 25 Nm |
q | replace |
7 - | Fuel tank |
q | when removing, support using the engine/gearbox jack, e.g. -V.A.G 1383 A- |
q | removing and installing → Chapter |
8 - | Circlip |
9 - | Support |
q | for exhaust pipe |
10 - | Tensioning strap |
q | Check fitting position |
11 - | Heat shield |
12 - | Sealing ring |
q | replace if damaged |
q | insert dry into the opening of the fuel tank |
q | must be moistened on the inside with fuel before assembly of the fuel delivery unit |
13 - | Fuel delivery unit |
q | with sender for fuel gauge display |
q | removing and installing → Chapter |
q | note the correct installed position of the fuel tank → Fig. |
q | inspecting fuel pump → Chapter |
q | Clean strainer if dirty |
q | removing and installing the sender for fuel gauge → Chapter |
14 - | Lock ring, 110 Nm |
q | slacken and tighten with wrench -T30101 (3087)- |
q | pay attention to correct position |
15 - | Return-flow line |
q | from fuel filter |
q | clipped in place on fuel tank |
q | pay attention to correct position |
q | blue |
16 - | Feed line |
q | to fuel filter |
q | clipped in place on fuel tank |
q | pay attention to correct position |
q | black |
17 - | Fuel tank lid unit |
q | with rubber bowl |
q | Removing and installing → Body Work; Rep. gr.55 |