Skoda Workshop Service and Repair Manuals > Octavia Mk2 > Vehicle electrics | Electrical System | Lights, lamps, switches outside | Steering column switch | Steering column switch - as of 06.10 | Removing and installing restoring ring with coil springF350 with integrated steering column electronics control unitJ527

Removing and installing restoring ring with coil springF350 with integrated steering column electronics control unitJ527

Removing and installing restoring ring with coil spring -F350- with integrated steering column electronics control unit -J527-

Removing

–	Remove steering wheel → Body Work; Rep. gr.69. Before the steering wheel is removed from the steering column, the wheels must be in the straightahead position.

–	Removing top and bottom steering column trim → Body Work; Rep. gr.70.

–	Lock the restoring ring -4- in the centre position (plug -3- is in the middle at the top) with adhesive tape -2-, if necessary with transport security.

–	Screw out screws -arrows-, disconnect plug -1- and slide the restoring ring -4- from the steering column.

Install

Installation is performed in the reverse order, pay attention to the following points:

Note

t	When assembling, the restoring ring with coil spring must be in the centre position and the wheels in the straightahead position. In case of doubt about the correct positioning of the ring rotor, the middle position of the restoring ring must be set before installing the steering wheel → Chapter.

t	The lever of the turn signal light must be in the 0 position so that the reset segment does not protrude and thus break.

t	The new control unit must be coded after the installation see → Vehicle diagnostic tester

Skoda Workshop Service and Repair Manuals