skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Contact assignment on the steering column electronics control unit J527 > < Removing and installing lever key of switch mounting on the steering column

Octavia Mk2

Removing and installing switch mounting on the steering column
Removing and installing switch mounting on the steering column
  Note
The fixing screws of the steering lock must be bored out in order to remove the switch mounting on the steering column. New pull-off screws are required for later installation → Electronic Catalogue of Original Parts.
  WARNING
When boring out the screws splinters can penetrate into the surrounding components and can cause damage and/or functional problems. Thus it is purposeful to remove these components before boring out the screws.
Removing
Remove the following components consecutively as follows:
–  Steering wheel → Body Work; Rep. gr.69.
–  Top and bottom steering column trim panel → Body Work; Rep. gr.70.
–  Steering column electronics control unit -J527- → Chapter.
–  Restoring ring with coil spring -F350- → Chapter.
–  Steering angle sender -G85- → Chapter (if present).
–  Left and right lever key → Chapter.
   
–  Disconnect plug connection from the reading coil -arrow-.
Bore out fixing screws -1- for steering lock with lock cylinder and ignition lock -3-.
–  Slide switch mounting -2- with steering lock out of the steering column.
  N94-10052
–  Release the retaining lugs -arrows- and remove the steering lock housing -2- from the mounting -1-.
Install
  A94-0638
–  Insert steering lock with lock cylinder and ignition lock -3- into the switch mounting -2-.
–  Fit switch mounting with steering lock as far as possible onto the steering column.
–  Insert plug connection -arrow- into the reading coil at the lock cylinder.
–  Screw on steering lock with new pull-off screws -1- and tighten until the screw heads are torn off.
–  Install the other components in reverse order.
  N94-10052

Contact assignment on the steering column electronics control unit J527 > < Removing and installing lever key of switch mounting on the steering column