skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing ignition key anti-removal lock solenoidN376 > < Removing and installing steering lock - as of 06.10

Octavia Mk2

Removing and installing the ignition switch
Removing and installing the ignition switch
Removing
–  Disconnect battery earth strap → Chapter.
  Note
The steering wheel must not be removed. For installing the fixing screws of the bottom trim panel for steering column, turn the steering wheel to the left by 90° and subsequently turn it to the right.
–  First of all remove the top and then the bottom steering column trim panel → Body Work; Rep. gr.70.
   
–  Release cover -1- (if present) for ignition starter switch by inserting a small screwdriver in the opening -arrow- and lift off the cover -movement arrow- through extensive levering off and remove.
–  Disconnect plugs -3- from ignition starter switch -2-.
  S94-0210
–  Release ignition starter switch by inserting two small screwdrivers (e.g. watch-and-clock screwdriver) in the openings -arrows-and by levering off the catch pegs.
–  Pull ignition starter switch -1- out of the steering lock.
Install
–  Installation is performed in the reverse order, pay attention to the following points:
  Note
When installing the ignition/starter switch and the steering lock must be in the same position, e.g. „Ignition ON“.
–  Insert ignition starter switch into the steering lock until there is an audible click.
–  Pay attention to the work sequence when connecting the battery → Chapter.
  S94-0211

Removing and installing ignition key anti-removal lock solenoidN376 > < Removing and installing steering lock - as of 06.10