skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the spray nozzles for windscreen washer system > < Windscreen washer system

Octavia Mk2

Remove and install reservoir, pumps and sensor for washer fluid level
Remove and install reservoir, pumps and sensor for washer fluid level
Removing
  Note
t  Depending on the version, the positions of the individual components and the hose connection can differ slightly from the version in the illustrations. The removal occurs in the same way.
t  For vehicles with auxiliary heating, there is a different arrangement of the pumps and the sensors at the reservoir, however their separation procedure is identical.
–  Switch off the ignition and all electrical components.
–  Remove front bumper → Body Work; Rep. gr.63.
   
–  Release plug from the washer fluid pumps for windscreen -2-, for headlight -10- and from sensor for washer fluid level -6-.
–  To unlock turn the locking clip on the hose connections -5- (black marking - front windscreen washer) and -3- (white marking - rear windscreen washer) and disconnect the connections from the washer fluid pump -4-. Collect the flowing out washer fluid in a suitable vessel.
–  Release washer hose for headlight -8- by pressing the locking clip and detach.
–  If necessary pull the washer fluid pumps -9- and -4- out of the reservoir to the top as well as the sensor for washer fluid level -7- out of the rubber bearing.
–  Expose wiring loom.
  N92-10095
–  Loosen pipe -3- for activated charcoal filter system or pipe for auxiliary heating from filler neck -2- of windshield washer reservoir.
–  Remove cap from reservoir supports.
–  Release screw -1- (8 Nm).
Vehicles without auxiliary heating system
  S92-0068
–  Screw out screws and nuts -arrows- (8 Nm) and remove windshield washer fluid reservoir downwards.
Vehicles fitted with auxiliary heating
  S92-0063
–  Unscrew fixing screws -arrows- (8 Nm).
–  Push the reservoir slightly forwards, during this procedure slacken it from the bearing in the bracket and remove it to the bottom.
Install
Installation is performed in the reverse order, pay attention to the following points:
–  Hoses with angled pieces must click audibly into the connections on the washer fluid pumps.
–  After completing the assembly work bleed the headlamp cleaning system → Chapter
  S92-0095

Removing and installing the spray nozzles for windscreen washer system > < Windscreen washer system