skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Testing the intake system for tightness (unmetered air) > < Inspecting the injection rate, tightness and jet formation of the injectors

Roomster

Testing intake manifold preheating
Testing intake manifold preheating
Roomster
For engine with identification characters BME
Special tools and workshop equipment required
t  Cooling spray
Testing control flap
–  Remove engine cover with air filter → Chapter.
   
–  Check position of the regulating flap -1-.
t  The flap must close off the warm air connection when the temperature exceeds 23°C.
t  The flap must open the warm air connection when the temperature is below 10°C.
  Note
The operation of the thermo-element -2- can easily be tested by spraying on a cooling spray.
  S24-0578

Testing the intake system for tightness (unmetered air) > < Inspecting the injection rate, tightness and jet formation of the injectors