skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the cylinder head > < Cylinder head - summary of components

Roomster

Removing and installing Hall senderG40
Removing and installing Hall sender -G40-
Removing
–  Removing toothed belt → Chapter.
   
–  Disconnect the plug -arrow- from the Hall sender -G40-.
  N15-10598
–  Unscrew the bracket -arrow- for the plug of the Hall sender -G40-, remove the plug from the bracket and place down the cable.
  N19-10411
–  Loosen the retaining lugs -top arrows- of the cable guide with a screwdriver and remove the cover of the -repair opening-„bottom arrow“.
  N15-10484
–  Unscrew the Hall sender -G40--arrow- from the cylinder head and guide its plug through the „repair opening“ in the toothed belt guard.
Install
Installation is performed in the reverse order, pay attention to the following points:
t  Close the repair opening in the toothed belt guard with a rubber plug → Electronic Catalogue of Original Parts.
t  Tightening torque of the fixing screw of the sender 10 Nm.
–  install toothed belt and set the timing → Chapter.
  A23-0257

Removing and installing the cylinder head > < Cylinder head - summary of components