Skoda Workshop Service and Repair Manuals

Removing and installing tensioning element for V-ribbed belt (Fabia II, Roomster) Removing –  Remove V-ribbed belt → Chapter.

–  Remove right charge air hose.

–  Unlock the catch peg with a finger and pull the fuel preheating valve upwards out of the guide of the coolant expansion bottle.

–  Unscrew the screws of the coolant expansion bottle -arrows-. –  Disconnect the plug -1- from the expansion bottle and remove the coolant expansion bottle and place it on the engine.

–  Install supporting device -MP9-200 (10-222A)- and support the engine with spindle -B- in fitting position. Allow spindle -A- to hang loosely.

–  Remove the earth connection -1- from the assembly bracket. –  Remove the screws -arrows- of the assembly bracket → Chapter. –  Carefully lower the engine sufficiently so that the tensioning element can be taken out.

–  Release screws -arrows-. –  Loosen hose clamp -2-. –  Disconnect the plug -1- at the charge pressure sender -G31- with intake air temperature sender -G42- and remove the right charge air pipe.

–  Unscrew screw -2- and remove tensioning element -1- from V-ribbed belt. Install Installation is performed in the reverse order, pay attention to the following points:

–  Install the screws -arrows- of the assembly bracket → Chapter. t  Tightening torques: → Chapter. –  Replace the screw of the tensioning element for the V-ribbed belt. –  Install the V-ribbed belt → Chapter.