Removing and installing the control unit for multimedia systemJ650 with integrated socket
Removing and installing the control unit for multimedia systemJ650 with integrated socket
Removing and installing the control unit for multimedia system -J650- with integrated socket
The control unit for multimedia system -J650- with integrated socket is located below the glove compartment/front passenger's side.
Removing
–
Switch off the ignition and all electrical components.
–
Remove the damping trim panel below the dash panel/front passenger's side.
–
Carefully wedge the screwdriver -see fig.- and slightly lever off the glove compartment -2--arrow A-.
–
Support it on the glove compartment from the rear via the plastic cover -1--arrow B- and press the glove compartment -2- out of the dash panel -arrow C-.
–
Disconnect the plug connection.
–
Slightly raise the clamp -2- with the latch clips -arrows A- and push out the control unit -1--arrows B-.
Install
Installation is performed in the reverse order, pay attention to the following points: