skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the ignition switch > < The starter device switch and lock cylinder

Roomster

Removing and installing lock cylinder
Removing and installing lock cylinder
Removing
–  Remove steering wheel → Body Work; Rep. gr.69.
–  Removing top and bottom steering column trim → Body Work; Rep. gr.70.
   
–  Carefully pull out the plug connector -arrow- of the reading spool for the vehicle immobiliser on the lock cylinder.
  Note
The reader coil for the vehicle immobiliser is fixed to the lock cylinder and cannot be replaced separately.
  N94-0205
–  Insert ignition key into lock cylinder and turn in such a way that the marking on the reading coil -1- is opposite the hole in the lock cylinder -2-.
–  Insert steel cable (about Ø 1.2 mm) into the hole -2- next to the key.
  S94-0231
–  Use the steel cable -2- to unlock the securing lever -3- of the lock cylinder -arrow- and pull the lock cylinder with the inserted key out of the steering lock housing.
Install
–  Insert ignition lock into the lock cylinder, turn and insert steel cable (see removal).
–  Insert lock cylinder into the steering lock housing.
  Note
t  Please ensure when inserting the lock cylinder that the connection for the reading spool of the vehicle immobiliser is lying in the guideway for the steering lock housing.
t  If the lock cylinder with the reader coil including the key was replaced, adapt immobiliser with → Vehicle diagnostic tester
–  Fit the plug connection together on the reading coil.
–  Installing top and bottom steering column trim → Body Work; Rep. gr.70.
–  Observe correct mounting sequence of steering wheel and airbag → Body Work; Rep. gr.69.
  S94-0193

Removing and installing the ignition switch > < The starter device switch and lock cylinder