Skoda Workshop Service and Repair Manuals > Superb > Body | Body Work | Rear door,sliding door,wing doors,central locking | Rear door

Removing and installing the door handle

Special tools and workshop equipment required

t	Assembly tool -T10118-

Removing

–	Remove door seal -1- around the door handle.

–	Pull and hold the door handle -2- in the direction of the arrow. Loosen the screw -4- by approximately 3 turns using a screwdriver. The housing is detached.

Note

If the screw is unscrewed too far the catch ring may separate from the bracket and fall inside the door.

–	Pull out housing -3- from the clamp of the door handle at a right angle to the door.

–	Unclip clip -1- from the door handle.

–	Swivel door handle out of the door.

Install

–	Swivel door handle into the door.

–	Hang the assembly tool -T10118- (-1-) in the spring fixed to the door lock -arrow A- and hang the spring in the lock lever -arrow B-.

–	Draw clip -1- in the plate opening and clip into door handle -2-.

Note

During assembly keep the door handle -2- pressed against the door panel.

Install housing as for lock cylinder housing → Chapter.

Note

Perform a functional check because the door cannot be opened if the adjustment is not accurate and the Bowden wire is not clipped on correctly.

Skoda Workshop Service and Repair Manuals