Superb
Summary of components of rear door seals |
1 - | Inside door seal |
q | The joining must be at a distance -A- of approx. 300 mm above the door bottom |
q | fit the seal starting in the top radius of the door opening |
2 - | Outside door seal |
3 - | Guide rail |
q | Removing: |
– | Remove cover Pos. 11 from the window run. |
– | Remove screws Pos. 12. |
– | Release the outside window shaft seal Pos. 7 from the door. |
– | Remove the guide rail from the window run. |
q | Installing: |
Installation is carried out in the reverse order. |
4 - | Screw |
5 - | Screw |
6 - | Screw |
7 - | Outside channel seal |
8 - | Rear door |
9 - | Screw |
10 - | Inner channel seal |
11 - | Cover of window run |
12 - | Screw |
13 - | The window shaft seal on the inside |
14 - | The door window pane |
15 - | Trim for door window frame |
q | Removing: |
– | Remove outer channel seal Pos. 7. |
– | Remove screw Pos. 5. |
– | Release the outer door seal Pos. 2 from the door frame. |
– | Remove screws Pos. 4. |
– | Remove trim from door window frame. |
q | Installing: |
Installation is carried out in the reverse order. |
16 - | Top door seal |
q | self-adhesive |