Inspecting ceramic pencil type glow plugs |
Special tools and workshop equipment required |
t
| Handheld multimeter -V.A.G 1526 B- |
–
| Connect handheld multimeter -V.A.G 1526 B- for resistance measurement between contact and glow plug housing. |
l
| Specified value: less than 1 Ω |
If the specified value is exceeded (greater than 1 Ω): |
–
| Remove the related ceramic pencil type glow plug and check it again for fracture of the pin. |
Note If a pin is fractured, the fractured pieces must be removed from the engine before the 1st engine start, otherwise this will always lead to an engine damage (seizing of a piston). If necessary, remove the cylinder head. |
–
| Re-insert pulled out plug connections of the ceramic pencil type glow plugs. |
| 1. Interrogating and erasing fault memory of engine control unit. Do not start the engine! |
| 2. Performing self-diagnosis. |
| 3. Interrogate the fault memory on the engine control unit again. Do not start the engine! |
Note If a fault memory entry regarding the ceramic pencil type glow plugs is stored, the engine must not be started! |
–
| Check el. wiring as well as plug connections of the ceramic pencil type glow plugs. |
|
|
|