skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Summary of components: assembly carrier, suspension arm, track rod for rear axle, vehicle level sensor -G76- (vehicles with fron > < Summary of components: Anti-roll bar (vehicles with front-wheel-drive)

Yeti

Removing and installing bracket for the speed sensor cable
Removing and installing bracket for the speed sensor cable
Removing:
   
–  Unclip speed sensor cable -1- from the holder.
–  Unclip the top part of the holder -arrow A- from the tab -arrow B- and open the holder.
–  Remove the holder from the top suspension arm -2-.
Installing:
  S42-0239
–  Push the opened holder -2- from below onto the top suspension arm -1-.
  Note
The surrounding components are not shown in the illustration for purposes of clear presentation.
–  Insert the holder at the top suspension arm and position the holder in such a way, that the dent -arrow B- and the recess -arrow A- are flush.
  S42-0240
–  Close holder: Interlock part of the holder -arrow A- with the tab -arrow B-.
–  Clip the speed sensor cable -1- into the holder.
  S42-0239

Summary of components: assembly carrier, suspension arm, track rod for rear axle, vehicle level sensor -G76- (vehicles with fron > < Summary of components: Anti-roll bar (vehicles with front-wheel-drive)