Yeti
Summary of components of front wing |
1 - | Noise insulation |
2 - | Nut, 8 Nm |
3 - | Front wing |
Removing: |
– | Remove trim panel of pillar A on the outside → Chapter. |
– | Remove front wheelhouse liner → Chapter. |
– | Remove separator panel → Chapter. |
– | Take out noise insulation -1-. |
– | Unscrew nuts -2-. |
– | Partially slacken the bumper corner. |
– | Remove the fixing screws -4- for the front wing. |
– | Remove the front wing. |
Installing: |
– | Installation is carried out in the reverse order; pay attention to the following points: |
Adjust front wing → Rep. gr.00. |
4 - | 8 Nm |
5 - | Top wing support |
6 - | Bottom wing support |