Yeti
Electrical/electronic components and fitting locations ABS Mark 70 (ABS/TCS) - as of CW 22/2010 |
1 - | ABS control unit -J104- |
q | Fitting location for left-hand drive: at hydraulic unit in right of engine compartment |
q | Fitting location for right-hand drive: at hydraulic unit in left of engine compartment |
q | check → Vehicle diagnostic tester |
q | do not disconnect the plug connector before the self-diagnosis is complete. switch off the ignition before disconnecting the plug connector. |
q | Removing and installing control unit and hydraulic unit - Vehicles with left-hand drive → Chapter |
q | Removing and installing control unit and hydraulic unit - Vehicles with right-hand drive → Chapter |
2 - | Hydraulic unit for ABS -N55- |
q | Fitting location for left-hand drive: at hydraulic unit in right of engine compartment |
q | Fitting location for right-hand drive: at hydraulic unit in left of engine compartment |
The hydraulic unit consists of these components: |
q | ABS hydraulic pump -V64- |
q | check → Vehicle diagnostic tester |
q | Valve block, (includes the inlet and exhaust valves) |
q | Do not separate the hydraulic pump -V64- from the valve block. |
q | Removing and installing control unit and hydraulic unit - Vehicles with left-hand drive → Chapter |
q | Removing and installing control unit and hydraulic unit - Vehicles with right-hand drive → Chapter |
3 - | Warning light 2 for ESP and TCS -K216- |
q | Operation: → Chapter |
4 - | ABS warning light -K47- |
q | Operation: → Chapter |
5 - | Warning light for traction control system -K86- |
q | Operation: → Chapter |
6 - | Dual circuit and hand brake system warning light -K7- |
q | Operation: → Chapter |
7 - | Brake pad warning light -K32- |
q | Operation: → Chapter |
8 - | Warning light for tyre pressure display -K220- |
q | Operation: → Chapter |
9 - | Brake light switch -F- and brake pedal switch -F47- |
q | Fitting location: on master brake cylinder |
q | removing and installing → Chapter |
q | check → Vehicle diagnostic tester |
10 - | Button for tyre pressure inspection -E226- |
q | Fitting location: in the centre console |
11 - | Switch for the Traction Control System -E132- |
q | Fitting location: in the centre console |
12 - | Diagnostic connection |
q | Fitting location: Cover in driver's footwell |
13 - | Front right and left wheel speed sensors -G45-/-G47- |
q | check → Vehicle diagnostic tester |
q | removing and installing → Chapter |
14 - | Wheel-bearing housing - front axle |
15 - | Wheel hub with wheel bearing |
q | Sensor ring for ABS is built into the wheel hub |
16 - | Rear right and left wheel speed sensors -G44 -/-G46- |
q | check → Vehicle diagnostic tester |
q | removing and installing → Chapter |
17 - | Wheel-bearing housing - rear axle |
18 - | Wheel hub with wheel bearing |
q | Sensor ring for ABS is built into the wheel hub |