Yeti
|
| 1 - | Brake line, 14 Nm |
| q | from master brake cylinder (floating piston circuit) to ABS hydraulic unit |
| q | Distinguishing feature: pipe screw with thread M12 x 1 |
| 2 - | Brake line, 14 Nm |
| q | from master brake cylinder (push rod piston circuit) to ABS hydraulic unit |
| q | Distinguishing feature: pipe screw with thread M12 x 1 |
| 3 - | Brake servo unit |
| q | on petrol engines, the required negative pressure is drawn from the induction pipe or it is generated with a vacuum pump → Chapter |
| q | vehicles using a diesel engine are fitted with a vacuum pump for generating a low pressure → Chapter |
| q | Inspect proper operation: |
| – | With the engine off press down brake pedal repeatedly with force (this reduces the pressure already present in the device). |
| – | Now hold the brake pedal in brake position using a medium foot pressure and start the engine. If the brake servo unit operates perfectly the brake pedal must yield noticeably under your foot (servo boost takes effect). |
| q | if there are faults replace completely |
| q | removing and installing → Chapter |
| 4 - | Brake line, 14 Nm |
| q | to front right brake caliper |
| q | Distinguishing feature: pipe screw with thread M12 x 1 |
| 5 - | Brake line, 14 Nm |
| q | to front left brake caliper |
| q | Distinguishing feature: Pipe screw with thread M10 x 1 |
| 6 - | ABS control unit -J104- |
| q | removing and installing → Chapter |
| 7 - | Screw, 5,5 Nm |
| 8 - | Hydraulic unit for ABS -N55- |
| q | removing and installing → Chapter |
| 9 - | Support |
| – | Moisten the bolt of the support with lubricant, e.g. -D 007 000 A2-, before inserting into the rubber bearings |
| q | after installing, check for tight fit |
| 10 - | Rubber bearing |
| q | make sure that the rubber bearings are not pressed out of the console when installing the bracket |
| 11 - | Console |
| q | before installing the rubber bearings → Item, moisten the holes for rubber bearings with lubricant, e.g. -D 007 000 A2- |
| 12 - | Nut, 20 Nm |
| 13 - | Screw, 8 Nm |
| 14 - | Brake line, 14 Nm |
| q | to rear left brake caliper |
| q | Distinguishing feature: pipe screw with thread M12 x 1 |
| 15 - | Brake line, 14 Nm |
| q | to rear right brake caliper |
| q | Distinguishing feature: Pipe screw with thread M10 x 1 |
